Printable Area - Epson TM-T88IIP Manual

CONFIDENTIAL

1.6 Printable Area

1) Paper roll
The printable area of a paper with width of 79.5 ± 0.5 mm (3.13" ± 0.02") is 72.2 ± 0.2 mm
(2.84" ± 0.008") (512 dots) and the space on the right and left sides are approximately
3.7 ±2 mm (0.15" ± 0.079").
b
d
For 58mm paper width model
The printable area of a paper with width of 57.5 ± 0.5 mm (2.26" ± 0.02") is 50.8 ± 0.2 mm
(2.00" ± 0.008") (360 dots) and the space on the left side is approximately 3.7mm (0.15")
and on the right side is approximately 3.0mm (0.12").
b
d
NOTE: The print position within the printable area of the thermal elements for dots 257 to 512 is
shifted approximately 0.07 mm (.003") in the paper feed direction from the position for
dots 1 to 256. Be sure not to print a ladder bar code across both printable areas, as this
can cause variations in printing which are difficult to read. However, when the ladder bar
code is printed with level 2 of print density, the difference is only approximately 0.04 ~
0.05 mm (.0015~.0019").
a
c
e
Figure 1.6.1 Paper Roll Printable Area
a
c
e
Figure 1.6.2 Paper Roll Printable Area
1 256
Approximately 0.07mm (0.0028")
Figure 1.6.3 Shifting of the Print Position
TITLE
TM-T88 II II II II series
Specification
(STANDARD)
a = 79.5 ± 0.5 mm (3.13" ± 0.02")
b = 0.141 mm ± 0.05 mm (.056" ± .002")
c = 72.2 mm ± 0.2 mm (2.84 ± .008")
d = 3.7 ± 0.2 mm (0.15" ± 0.079").
e = 3.7 ± 0.2 mm (0.15" ± 0.079").
[All the numeric values are typical.]
a = 57.5 ± 0.5 mm (2.26" ± 0.02")
b = 0.141 mm ± 0.05 mm (.056" ± .002")
c = 50.8 mm ± 0.2 mm (2.00 ± .008")
d = 3.7 ± 0.2 mm (0.15" ± 0.079").
e = 3.0 ± 0.2 mm (0.12" ± 0.079").
[All the numeric values are typical.]
257 512
SHEET
REVISION
D
NO.
SHEET
NEXT
5
6