Epson SC-S70600 series User Manual page 38

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
C
Loosen the roll holder fixing screws sufficiently
and adjust the roll holders so that the distance
between the two is wider than the media.
Center the roll supports between the roll holders.
c
Important:
If the right holder handle shaft is not visible,
rotate the handle forward until it stops. The
media can not be properly loaded if the handle
shaft is not visible.
D
Temporarily place media on the roll supports.
Basic Operations
Note:
The method of placing the roll media varies as
follows depending on how media is rolled.
Printable Side Out
Printable Side In
E
Align the left and right edges of the media with
the set positions according to the media width.
Recommended positioning by media width
"Positioning of the pressure rollers and
U
media (For SC-S70600 series and SC-S50600
series)" on page 35
Note:
If the label with black squares is not in place, affix
the label as described in the Setup Guide.
U Setup Guide
38