Removing The Take-Up Roll - Epson SC-S70600 series User Manual

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
c
Important:
❏ Always attach three each on the left and right.
Take-up will not be performed correctly if
counterweights are added to one side only or
the quantities are different on the left and
right.
❏ For media other than banner media, always
remove the counterweights before printing.
Failure to do so may cause the print head to
strike the media during printing.
To remove counterweights, open them in the
same way as when attaching them.

Removing the Take-up Roll

The procedure for removing media varies depending on
whether you are using the supplied auto take-up reel
unit or the optional auto take-up reel unit for heavy
media.
Follow the steps below when using the supplied auto
take-up reel unit.
Basic Operations
When the Heavy Roll Auto Take-up Reel Unit is
installed U
Take-up Reel Unit" on page 82
When the Standard Auto Take-up
Reel Unit Is Installed
This section describes how to remove media from the
take-up reel.
!
Caution:
❏ Because the media is heavy, it should not be
carried by one person.
❏ Follow the instructions in the manual when
removing media or take-up roll.
Dropping media or take-up rolls could result
in injury.
A
Cut the media and roll the cut end onto the
take-up reel.
"Cutting Media" on page 64
U
B
To prevent the media from sliding off the roll,
support the roll at its left end.
C
Loosen the left roll core holder fixing screw and
remove the roll core holder from the roll.
D
Lower the roll onto the roll support.
81
"Using the Optional Heavy Roll Auto