Epson SC-S70600 series User Manual page 53

EPSON SC-S70600 series/SC-S50600 series/SC-S30600 series User's Guide
Note:
If the media roll has an outer diameter that is less
than 140 mm, lift it manually, and load it to the roll
holder. The roll core will not reach the holder when
raised using the lift lever.
G
Tighten the roll holder screw until the screw no
longer turns to fix the roll holder in place.
H
Raise the lift lever on the right side of the printer
to lift the media into position, then firmly insert
the roll holder.
Basic Operations
Note:
If the media roll has an outer diameter that is less
than 140 mm, lift it manually, and load it to the roll
holder.
I
To ensure the roll holder is inserted into the roll
core sufficiently, push the center section on the
side of the roll holder towards the roll end twice.
c
53
Important:
If the roll holder is inserted into the roll core
insufficiently, media is not fed correctly
during printing because of slippage between
the roll holder and roll core.
This may cause banding in the print results.