Removing The Take-Up Roll; Setting Information Printing At Media Cut; Cutting Media - Epson SC-F10000 Series User Manual

SC-F10000 Series User's Guide
Removing the Take-up
Roll
Follow the steps below when replacing the media.
1. Set Information Printing at Media Cut.
2. Cut the media.
3. Remove the media.
Setting Information Printing at
Media Cut
Setting Information Printing at Media Cut in advance
is useful because information that is helpful when
managing media is printed whenever media is cut.
For example, when Paper Remaining Information is
turned On, the length of media that is remaining is
printed. By printing the remaining amount on the
media being removed, you can check this value the next
time the media is loaded and enter the media length.
This is useful for accurate management of the amount of
media remaining.
See the following for details about Information Printing
at Media Cut.
"General Settings menu" on page 150
U
Basic Operations

Cutting Media

Caution:
❏ The dryer may be hot; observe all necessary
precautions. Failure to observe the necessary
precautions could result in burns.
❏ Do not put your hand inside the dryer. Failure
to observe the necessary precautions could
result in burns.
❏ When cutting media, be careful not to cut your
fingers or hands with the cutter or other blades.
A
On the control panel screen, press the
then Forward.
If you want to adjust the cut position, change the
value of the position.
B
Turn Off the Auto switch of the Auto Take-up
Reel Unit.
C
Cut the media at the bottom of the media guide
bar using scissors.
85
and