Aficio C6055 Operating Instructions Manual page 216

5. Enhanced Network Security
Encapsulation Mode
5
IPsec Requirement Level
Authentication Method
Phase 1
HASH Algorithm
Phase 1
Encryption Algorithm
214
Setting
Specify the encapsulation
mode.
(auto setting)
Specify whether to only
transmit using IPsec, or to allow
cleartext transmission when
IPsec cannot be established.
(auto setting)
Specify the method for
authenticating transmission
partners.
(auto setting)
Specify the HASH algorithm to
be used in phase 1.
(auto setting)
Specify the encryption
algorithm to be used in phase
1.
(auto setting)
Description
address, or enter 128 after an
IPv6 address.
• Transport
• Tunnel
(Tunnel beginning address -
Tunnel ending address)
If you specify "Tunnel", you
must then specify the "Tunnel
End Points", which are the
beginning and ending IP
addresses. Set the same
address for the beginning point
as you set in "Local Address".
• Use When Possible
• Always Require
• PSK
• Certificate
If you specify PSK, you must
then set the PSK text (using
ASCII characters).
If you specify Certificate, the
certificate for IPsec must be
installed and specified before it
can be used.
• MD5
• SHA1
• DES
• 3DES
Setting Value