Internal Supply - Intermec EasyCoder 601 XP Service Manual

5.1 Internal Supply,

cont'd.
Flange
Disc
Felt Pad
Shaft
1
/. Refer to Appendix 2 for a de-
scription of how to check the brake
torque.
Intermec EasyCoder 601 XP – Service Manual Ed. 2
The bobbin package can be dismantled by removing the #T20 Torx
screw at the end of the shaft. Inside the outermost bobbin, there is
a spring that presses the bobbin package towards a felt pad in order
to break the rotation. Else, the momentum of a large and heavy
paper roll might cause excessive paper to be unwound when the
printing is stopped. The brake torque should be 70 ±20 Nmm
The code disc fitted at the innermost part of the bobbin package has
no use in EasyCoder 601 XP, but is retained for logistic reasons
(common assembly with EasyCoder 501/601). Be careful to fit the
studs of the innermost bobbin into the holes in the code disk when
the package is assembled.
Code Disc
Chapter 5 Paper Supply
Bobbins
Nylon Disc
Spring
Washer
#T20 Torx Screw
1
.
25