Main Parts - Intermec EasyCoder 601 XP Service Manual

Chapter 9 Paper Rewind Kit

9.2 Main Parts

The stepper motor is fitted to the printer's centre-line wall by means
of a motor support plate. It drives the rewind unit and the rewind
roller in the print unit via two belts. The tension of these belts can
be slightly adjusted by moving the stepper motor and/or support
plate before the screws are tightened.
The paper rewind unit is fitted with a brace, that holds the paper. The
unit is fitted to the printer's centre-line wall by means of two #T20
Torx screws that can be accessed through holes in the CPU board
(turn off the power first!).
A break shaft in front of the rewind unit guides the paper to be
rewound under the slack absorber.
The stepper motor is connected to P421 on the CPU board, see
chapter 15.3.
Stepper Motor
Motor Support Plate
Belt to Rewind Unit
Belt to
Rewind Roller
Tension Roller
Brace
Backing Paper
Rewind Unit
Break Shaft
Intermec EasyCoder 601 XP – Service Manual Ed. 2 71