Internal Rewinder Mechanism - Intermec pm43 Service Manual

TITLE
PM43 Service Work Instructions

Internal Rewinder Mechanism

OPERATION:
The internal rewinder is a factory configurable option. Printers built without the internal rewinder option can be retrofitted to
include the internal rewinder by Intermec Service Depots or third party service depots that are authorized by Intermec.
Tools Required
Description
Torx Driver
Torx Driver
Allen Driver, 1.5mm-2.0mm
Parts Required
Item Part Number
1 710-090S-001
2 715-616S-001
3 710-168-001
4 234-053S-0300
5 825-218-001
6 710-089S-001
7 657-030-001
8 653-679-001
9 1-994059-008
10 1-994058-004
Label Taken Sensor (LTS) Replacement
1. Remove the media and electronic cover.
2. Remove the front panel. See page 11 on how to remove the front panel.
3. Disconnect sensor cable from P29 connector on the main logic board.
4. Remove Torx screwing the sensor mounting plate and remove the sensor assembly. See Figure 1.
5. Reverse the procedure to install replacement sensor assembly
Description
Internal Media Rewinder, Sub-Assy, Spare Kit, PM43 (include stepper motor,
rewinder assembly, belt, stepper rewinder PCBA)
Label Taken Sensor (LTS), Spare Kit, PM43
Motor,Stepper Rewind PM43 (does not include mount plate as shown)
PCB Assy, Rewind Motor Driver
Belt,Rewinder PM43
Media Rewinder, Sub-Assembly, PMB43
Shaft, Media Divert, Spare, PM43
Plate, Batch, PM43
Screw, MRT 4x8 ZP, T20 (14 lbf.in/16 kgf.cm) – Mounting Torx screws
Screw, MRT 3X4 ZP, T10 (5 lbf.in/6 kgf.cm) – Included with LTS spare kit
10
6
Figure 1
Intermec Proprietary Document
Model DOCUMENT NO.
PM43,PM43C SWIPM43x-000
Part Number
T10
T20
Label Taken Sensor (LTS) Spare
PAGE
Page
60 of 70
Qty
1
1
1
1
1
1
1
1
8
2
2
6