Intermec EasyCoder 601 XP Service Manual page 37

7.3 Ribbon Rewind
Unit,
cont'd.
Gear Wheel
Ball Bearing
Flange
Carrier
Grub Screw
Friction Felt
Intermec EasyCoder 601 XP – Service Manual Ed. 2
Dismantling
To remove the unit, remove the two #T20 Torx screws that hold the
flange from inside the electronics compartment and pull the belt off
the gear wheel. Then dismantle the gear wheel by removing the
circlip. Now you can pull the remaining parts of the unit out into the
paper compartment.
To dismantle the unit further, remove the #T20 Torx screw and
washer at the end of the shaft and pull off the bobbin, the compres-
sion spring and the nylon washer. Then you can inspect the friction
felt. No further dismantling is normally required.
Reassemble in reverse order, making sure that the one-way clutch
in the gear wheel works in the correct direction. Finally, fit the belt
over the gear wheel, adjust the tension of the belt as described in
chapter 8.5, and tighten the screws that hold the flange.
Ball Bearing
Spring
Washer
Circlips
Shaft
Chapter 7 Transfer Ribbon Mechanism
Slide Bearing
Friction Plate
Bobbin
Washers
Compression Spring
0–4 Torque Adjustment
0–1 Torque Adjustment
#T20 Torx Screw
Bobbin Plate
Slide Bearing
Washer
36