Epson Artisan 700 Service Manual page 204

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Setting procedure
The MAC address required on the adjustment program is
C A U T I O N
written on the MAC address label on the Upper M/B Shield
Plate.
Make sure that the address written on the MAC address label
matches the MAC address settings in the EEPROM.
Label, MAC address
Figure 5-9. MAC Address Label
Do not use the MAC address of the label attached to the
Wireless LAN Board since the address is not used for this
product.
1. Start the adjustment program.
2. Select the "Initial Setting" from the menu. The initial setting screen appears.
3. Enter the last six digits of MAC address into the MAC address entry field, and
click the MAC Address input button.
(Enter the address again into the second entry field to confirm it.)
4. Select the network status sheet print menu on the printer's control panel, and print
the sheet. Check the MAC address printed on the sheet to see if it is correct. refer
to Figure 1-11 "Sample of Network Status
ADJUSTMENT
the last six digits of MAC address
Sheet".
Adjustment Using Adjustment Program
Figure 5-10. MAC Address Setting Screen
Revision C
224
Confidential