Epson Artisan 700 Service Manual page 132

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Be careful not to damage the Pinion Gear of the PF Motor.
C A U T I O N
5. Remove the screws (x2) that secure the Tension Holder reinforcing plate and
remove the Holder.
Tension Holder
reinforcing plate
Figure 4-120. Removing the PF Motor (3)
6. Remove the screw (x1) that secures the PF Motor, and remove the PF Motor
while drawing out the Pinion Gear from the hole of the Main Frame.
Hole
Figure 4-121. Removing the PF Motor (4)
DISASSEMBLY/ASSEMBLY
Positioning hole & dowel
C.B.S. 3x6 (8±1Kgfcm)
C.P. 3x5 (4±0.5Kgfcm)
Pinion Gear
PF Motor
C.P. 3x5 (4±0.5Kgfcm)
Disassembly Procedures
When installing the PF Motor, keep the groove of the PF Motor
upward.
PF Motor
Figure 4-122. Installing the PF Motor
When installing the Spacer, align the positioning holes (x2) of the
Spacer with the dowels (x2) of the Holder.
Make sure there is no gap between upper left end of the Spacer
and the Tensioner. If there is a gap, turn the Spacer around or
over so that another letter (2, 4, or 1 ) comes to the upper left and
install it. (See Fig. 4-118 and Fig.
PF Timing Belt
No gap between the Spacer and
the Tensioner.
Tensioner Spacer
Normally, the Spacer should be attached so
that the letter "3" on it comes to upper left.
However, if you see a gap between the
Spacer upper left end and the Tensioner, turn
the Spacer around or over and install it.
Figure 4-123. Installing the Spacer
Revision C
Groove
4-123.)
Front side Back side
151
Confidential