Epson Artisan 700 Service Manual page 228

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Refer to the following figures for the lubrication points.
Apply the grease through the holes. (x2)
Carriage Shaft
Carriage Unit
CR guide plate Application Point
Figure 6-1. Lubrication of the Carriage Shaft and CR guide plate
MAINTENANCE
<Lubrication Points>
1. Two contact points between
the Carriage Unit and the
Carriage Shaft.
2. Two contact points between
the Carriage Unit and the CR
guide plate.
3. Two lubrication holes on top of
the Carriage Unit.
<Type>
G-71
<Application Amount>
±
1. 100 20 mg
±
2. 170 20 mg
3. 190 ± 20 mg
<Application Timing>
After installing the Carriage Unit
and the Carriage Shaft
<Remarks>
Apply with injector
1. After lubrication, move the
Carriage Unit from side to side
while rotating the Carriage
Shaft to spread the grease
evenly.
Overview
PG Cam L
Left Parallelism Bushing
Right Parallelism Bushing
PG Cam R
Application Point
Figure 6-2. Lubrication of the
Left Front PG Cam
Right Front PG Cam
Application Point
Figure 6-3. Lubrication of the Left Front PG Cam and Right Front PG Cam
Revision C
<Lubrication Points>
1. Contact points between the PG
Cam L and Left Parallelism
Bushing
2. Contact points between the PG
Cam R and Right Parallelism
Bushing
<Type>
G-71
<Application Amount>
1. φ 1 x sliding surface
2. φ 1 x sliding surface
<Application Timing>
After installing the PG Cam L and
the PG Cam R
<Remarks>
Apply with injector
and
Left PG Cam Right PG Cam
<Lubrication Points>
1. Sliding surface of the Left
Front PG Cam
2. Sliding surface of the Right
Front PG Cam
<Type>
G-71
<Application Amount>
1. φ 1 x sliding surface
2. φ 1 x sliding surface
<Application Timing>
Before installing the Left Front
PG Cam and Right Front PG Cam
<Remarks>
Apply with injector
Confidential
250