Cr Scale - Epson Artisan 700 Service Manual

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
Confirm that there is no ink penetrating into the Decompression
C H E C K
Tube located inside the Ink Supply Tube Assy. If such ink
P O I N T
penetration is observed, make sure to replace the Ink Supply IC
Holder Assy (p133) together with the Printhead.
After removing/replacing the Printhead, make the specified
A D J U S T M E N T
R E Q U I R E D
adjustments. (See
When disconnecting the joint of the Printhead and the Ink
Tube, in particular, the Leak Check is necessary.
If the position of the notch on the Parallelism Adjustment
Busings have not changed, only
adjustment (p239)" is necessary. ( See
DISASSEMBLY/ASSEMBLY
Chapter 5 "ADJUSTMENT".)
"Checking the result of PG
"PG Adjustment

4.2.4.2 CR Scale

Parts/Components need to be removed in advance:
ADF Unit (Artisan 800/PX800FW/TX800FW only)/Scanner Unit/Upper Left
Housing/Paper Guide Top Assy/Upper Housing
Removal procedure
Do not touch the CR Scale with bare hands.
C A U T I O N
Do not damage or contaminate the CR Scale.
Take care not to damage (extend too much) the Torsion Spring
16.43.
(p235)".)
1. Release the Carriage Lock and move the Carriage Unit to the center. (See
4.2.4.1 Printhead Step2
2. Release the right side of the CR Scale from the hook.
3. Pull out the CR Scale from the slit of the CR Encoder Sensor.
Slit of CR Encoder Sensor
Disassembly Procedures
(p125).)
Hook
CR Scale
CR Scale
Figure 4-69. Removing the CR Scale(1)
Revision C
129
Confidential