Card Slot Assy - Epson Artisan 700 Service Manual

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W

4.2.3.5 Card Slot Assy

The disassembly/reassembly procedures of Epson Artisan 700/
C H E C K
Epson Stylus Photo PX700W/TX700W differ from those of
P O I N T
.
See 4.3.2.3 "Card Slot Assy (Artisan 700/PX700W/TX700W)"
(p199) for the procedures.
The Card Slot Assy includes the SUB Board and the STG
Board.
When powering this product, high-voltage current may be applied
W A R N I N G
on the SUB Board. To prevent ELECTRIC SHOCK, do not touch
the SUB Board section when the power is ON.
If the shock should happen, the flowing current is very tiny, about a
few hundreds μA, therefore it will not do any harm on the human
body.
Parts/Components need to be removed in advance:
ADF Unit (Artisan 800/PX800FW/TX800FW only)/Scanner Unit/Upper Left
Housing/Paper Guide Top Assy/Upper Housing/Hinge/Rear Right FAX Housing/
Right Housing/Main Board Unit/Wireless LAN Board/CSIC Assy/Cartridge Box
Unit/Ink Supply Tube Assy
Removal procedure
1. Remove the screws (x2) that secure the Card Slot Assy and remove the
Grounding Plate.
Figure 4-53. Removing the Card Slot Assy (1)
DISASSEMBLY/ASSEMBLY
Card Slot Assy
Grounding Plate
Positioning hole & dowel
Dowel & groove
C.B.P. 3x8 (6±1Kgfcm)
2. Disconnect the AID cable from the connector on the SUB Board, and remove
the Card Slot Assy.
Card Slot Assy
Figure 4-54. Removing the Card Slot Assy (2)
Connect the AID cable properly to the connector on the SUB
Board. (See
Align the grooves (x2) of the Card Slot Assy with the dowels (x2)
of the Base Frame. (See
When attaching the Grounding Plate, install it over the Card
Slot Assy, and align the positioning hole of the Grounding Plate
with the dowel of the Base Frame, and tighten them together
with the screw. (See
For routing the FFCs, see
After removing/replacing the Card Slot Assy, make the specified
A D J U S T M E N T
R E Q U I R E D adjustments. (See
Disassembly Procedures
Connector on the SUB Board
AID cable
Fig. 4-54.)
Fig. 4-53.)
Fig. 4-53.)
4.4 "Routing FFC/cables"
Chapter 5 "ADJUSTMENT".)
Revision C
(p202).
123
Confidential