Epson Artisan 700 Service Manual page 107

Hide thumbs Also See for Epson Artisan 700:
Table of Contents

Advertisement

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
In the next steps, make sure to take measures against
C A U T I O N
contamination of the surroundings from ink such as receiving it
with BEMCOT or the like.
Using a piece of clean BEMCOT or the like, wipe off the leaked
ink when removing the Printhead.
Make sure not to touch the joint point of the Printhead and the
Ink Supply Tube Assy. (See
6.
Remove the screws (x2) that secure the Ink Supply Tube Assy and remove the
Ink Supply Tube Assy from the Printhead, then remove the Printhead.
1
Figure 4-60. Removing the Printhead (3)
DISASSEMBLY/ASSEMBLY
Fig.
4-60.)
Printhead
C.B.P. 2x10 (2.5Kgfcm)
Disassembly Procedures
ASSEMBLING THE PRINTHEAD
When assembling the Printhead, make sure to use the Ink Supply
C A U T I O N
Tube screwing tool following the procedure in this section in order
to avoid spilling ink from the joint of the Ink Supply Tube Assy and
the Printhead.
Ink Supply Tube screwing tool
Thickness gauge
Figure 4-61. Ink Supply Tube screwing tool
When installing the Printhead, confirm the CR Seal is not
C H E C K
folded or out of position, then install it without any gap in
P O I N T
between.
When the CR Seal gets out of position, make sure to align the
positioning holes (x2) of it with the dowels (x2) on the Carriage
Unit, then install it without any gap.
CR Seal
Figure 4-62. Installing the CR Seal
When installing the Printhead, make sure to move the Carriage
to the 80-digit side and place it on the Carriage stopper jig in
order to prevent the frame from deforming.
Revision C
Carriage Unit
Positioning hole & dowel
126
Confidential

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Epson stylus photo px700fwEpson stylus photo tx700fw

Table of Contents