Advertisement

Quick Links

KB / FAQ
Epson PX700 - PX730WD
Note: This guide also covers the following Epson printer models:
PX700W, PX710W, PX720WD, PX730WD
PX800FW, PX810FW, PX820FWD, PX830FWD
TX700, TX710W, TX720WD
TX800FW, TX810FW, TX820FWD
Artisan 700, 710, 725, 735
Artisan 800, 810, 835, 837
This guide is primarily aimed at OctoInkjet customers who have purchased a Solo-X waste kit (released May
2011) although customers with the earlier Solo+ can still apply some of the steps to their kit (but without a
part to act as the strain relief).
Note: This guide is copyright of OctoInkjet. It required 12 hours, the purchase of three printers (to check it
was all correct) and hard work to produce.
Please, if you see my work reproduced elsewhere, please report it to me, eBay (if provided by one of the
sellers there) or the appropriate authority so it can be removed. Competitors do not do the hard work, barely
understand the product and will not provide this level of documentation or support themselves so please do
not reward them by buying their kits.
OK... here are the step by step instructions fitting a Solo-X waste kit to a compatible printer.
1/4

Advertisement

Table of Contents
loading

Summary of Contents for Epson PX700

  • Page 1 KB / FAQ Epson PX700 - PX730WD Note: This guide also covers the following Epson printer models: PX700W, PX710W, PX720WD, PX730WD PX800FW, PX810FW, PX820FWD, PX830FWD TX700, TX710W, TX720WD TX800FW, TX810FW, TX820FWD Artisan 700, 710, 725, 735 Artisan 800, 810, 835, 837...
  • Page 2 Identify the Waste Pad Holder The waste pad in a PX700 is located above the metal plate you can see in the base of the printer (left). Remove Retaining Screw & Release Clip/Tab To release the waste pad holder, you need to remove the screw (indicated left)...
  • Page 3 Modifying the Case (not required) In order to get the tube out of the printer you can either, allow the tubing to drop out of, the open area and underneath the back of the printer or widen the screw hole (the one you removed the screw from to release the waste pad holder).
  • Page 4 The oldest PX/Artisan/TX models can be reset using an Adjustment utility for the TX700W / TX800FW. If you are in North America there is also an IPR tool released by Epson for the older models but many customers there have reported that it won't work after one reset (if at all).

Table of Contents