Epson Artisan 700 Service Manual page 115

Epson Artisan 700/Epson Stylus Photo PX700W/TX700W
To prevent ink leakage, make sure not to separate the Ink Supply
W A R N I N G
Tube Assy and the Cartridge Box Unit by removing the screws (x2)
on the section A shown in
section A even just once will cause ink leakage, therefore, make sure
to replace the Ink Supply IC Holder Assy with a new one.
5. Release the Clamp Tubes (x2). (See
6. Release the Ink Supply Tube Assy and FFC from the FFC Holder, and remove
the Ink Supply IC Holder Assy.
Ink Supply Tube Assy
FFC
Clamp
Tube
Figure 4-79. Removing the Ink Supply Tube Assy
DISASSEMBLY/ASSEMBLY
Fig. 4-79. Loosening the screws on the
Fig. 4-79.)
FFC Holder
Section A Cartridge Box Unit
Disassembly Procedures
Make sure to insert the decompression tube into the socket on
the Cartridge Box Unit to the full to its base. (See
Make sure to align the positioning hole (x1) on the Cartridge
Box Unit with the dowel (x1) of the Base Frame when
reassembling them. (See Fig. 4-80.)
When installing the Cartridge Box Unit, make sure to secure
the hooks (x2) on the Main Frame to their positioning holes
(x2). (See Fig. 4-80.)
Figure 4-80. Installing the Cartridge Box Unit
Make sure to attach the grounding plate to the place shown in
Fig. 4-78, and secure it with the screw.
Revision C
Fig. 4-71.)
Positioning hole & dowel
Positioning hole & hook
134
Confidential