Network - WatchNet ENX Series Manual

3.5.3.1 Quick Setup
Copy function allows you to copy one channel setup to another. After setting in channel 1, click
Copy button, you can see current channel name is grey such as channel 1. Now you can select
the channel you wan to paste such as channel 5/6/7. If you wan to save current setup of channel
1 to all channels, you can click the first box "ALL". Click the OK button to save current copy setup.
Click the OK button in the Encode interface, the copy function succeeded.

3.5.4 Network

Here is for you to input network information. See Figure 3-40.

Network Mode: It includes multiple address, fault tolerance, and load balancing.

Multiple-address mode: eth1 and eth2 and etc operate separately (Max support 4 network
ports). You can use the services such as HTTP, RTP service via eth1/2/3/4. Usually you
need to set one default card (default setup is eth1) to request the auto network service form
the device-end such as DHCP, email, FTP and etc.

Network fault-tolerance: In this mode, device uses bond0 to communicate with the external
devices. You can focus on one host IP address. At the same time, you need to set one
master card. Usually there is only one running card (master card).System can enable
alternate card when the master card is malfunction. The system is shown as offline once all
cards are offline.
Figure 3-38
Figure 3-39
29