WatchNet ENX Series Manual page 32


Channel: Select the channel you want.

Type: Please select from the dropdown list. There are three options: regular/motion
detect/alarm. You can set the various encode parameters for different record types.

Compression: According to the front-end parameter, system supports MPEG4, MS_MPEG4,
MPEG2, MPEG1, H263, MJPEG, FCC_MPEG4, H.264 and etc.

Resolution: The mainstream resolution type is IPC's encoding config such as D1/1080P.

Frame rate: It ranges from 1f/s to 25f/s in NTSC mode and 1f/s to 30f/s in PAL mode.

Bit rate type: System supports two types: CBR and VBR. In VBR mode, you can set video
quality.

Quality: There are six levels ranging from 1 to 6. The sixth level has the highest image
quality.

Video/audio: You can enable or disable the video/audio.

Overlay: Click overlay button, you can see an interface is shown in Figure 3-35.

Cover area (Privacy mask): Here is for you to set privacy mask section. You can drag you
mouse to set proper section size. In one channel video, system max supports 4 zones in one
channel.

Preview/monitor: privacy mask has two types. Preview and Monitor. Preview means the
privacy mask zone can not be viewed by user when system is in preview status. Monitor
means the privacy mask zone can not be view by the user when system is in monitor status.

Time display: You can select system displays time or not when you playback. Please click
set button and then drag the title to the corresponding position in the screen.

Channel display: You can select system displays channel number or not when you playback.
Please click set button and then drag the title to the corresponding position in the screen.

Snapshot: Click snapshot button, you can set snapshot mode, picture size, quality and
frequency. See Figure 3-34. Before the snapshot operation, please make sure the front-
end device supports current operation.

Snapshot mode: There are two modes: Timing (Schedule) and activation. If you set timing
mode, you need to set snapshot frequency. If you set activation snapshot, you need to go to
Detect interface (Main menu->Setting-Detect) to set snapshot activation operation.

Image size: Here you can set snapshot picture size.

Image quality: Here you can set snapshot quality. The value ranges from 1 to 6.

Snapshot frequency: It is for you to set timing (schedule) snapshot interval. The value ranges
from 1-7 picture(s) per second.

Copy：Before the Copy operation, please make sure you selected channel supports
current copy contents. After you complete the setup, you can click Copy button to copy
current setup to other channel(s). You can see an interface is shown as in Figure 3-36 (The
figure here is based on the 128-channel series product.). You can see current channel
number is grey. Please check the number to select the channel or you can check the box
ALL. Please click the OK button in Figure 3-36 and Figure 3-33 respectively to complete the
setup. Please note, once you check the All box, you set same encode setup for all channels.
Audio/video enable box, overlay button and the copy button is shield. See Figure 3-37.
Please highlight icon to select the corresponding function.
26