WatchNet ENX Series Manual page 18

Activate Patrol (tour)
In Figure 3-7, input patrol (tour) number in the No. blank and click patrol button
X341H341H 341H
Pattern Setup
In Figure 3-7, click pattern button and then click "begin" button. The interface is shown as in
Figure 3-11. Then you can go to Figure 3-5 to modify zoom, focus, and iris.
Go back to Figure 3-11 and click "end" button. You can memorize all these operations as pattern
1.
Activate Pattern Function
In Figure 3-8, input mode value in the No. blank, and click pattern button.
Auto Scan Setup
In Figure 3-9, click border button. The interface is shown as in Figure 3-12.
Please go to Figure 3-5, use direction arrows to select camera left limit
Then please go to Figure 3-12 and click left limit button
Repeat the above procedures to set right limit.
Activate Auto Scan
In Figure 3-8, click "Auto Scan" button, the system begins auto scan. Correspondingly, the auto
scan button becomes Stop button. Click stop button to terminate scan operation.
Flip
In Figure 3-8, click page switch button, you can see an interface is shown as below. See Figure
3-13. Here you can set auxiliary function. The aux value has relation ship with the Aux button of
the decoder.
Click page switch button again, system goes back to Figure 3-5.
Figure 3-11
Figure 3-12
12