WatchNet ENX Series Manual page 48


Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you enabled current function.

Send email: System can send out email to alert you when alarm occurs.

Record channel: System auto activates motion detection channel(s) to record once an alarm
occurs. Please make sure you have set MD record in Schedule interface(Main Menu-
>Setting->Schedule) and schedule record in manual record interface(Main Menu-
>Advanced->Manual Record)

PTZ activation: Here you can set PTZ movement when alarm occurs. Such as go to preset
when there is an alarm. Click "select" button, you can see an interface is shown as in
Figure 3-58 . Click PgUp/PgDn to set more channels.
X305H305H30 5H X

Record Delay: System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.

Tour: Here you can enable tour function when alarm occurs. System one-window tour.
Please go to chapter 3.5.7 Display for tour interval setup.
Please highlight icon
save button, system goes back to the previous menu.
Note:
In motion detection mode, you can not use copy/paste to set channel setup since the video in
each channel may not be the same.
In Figure 3-57, you can left click mouse and then drag it to set a region for motion detection.
Click Fn to switch between arm/withdraw motion detection. After setting, click enter button to exit.
to select the corresponding function. After all the setups please click
Figure 3-56
42