Abnormality - WatchNet ENX Series Manual


Once you change the HDD Group settings, system will pack the records and then begin
record again!

After you removed one HDD channel group, corresponding channel record will be saved on
the HDD of the same group.

3.7.2 Abnormality

Abnormality interface is shown as in Figure 3-74.

Event type: There are several options for you such as disk error, no disk, disconnection,
IP conflict, MAC conflict, redundant power and etc.

Alarm output: Please select alarm activation output port (multiple choices).

Latch: Here you can set corresponding delaying time. The value ranges from 1s-300s.
System automatically delays specified seconds in turning off alarm and activated output after
external alarm cancelled.

Show message: system can pop up the message in the local screen to alert you when
alarm occurs.

Alarm upload: System can upload the alarm signal to the network (including alarm centre)
if you enabled current function.

Send email: System can send out email to alert you when alarm occurs.

Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Figure 3-73
Figure 3-74
52