WatchNet ENX Series Manual page 83

Parameter
Network mode
Default card
Ethernet port
DHCP
IP Address
Default Gateway
TCP Port
HTTP Port
RTSP port
UDP Port
Max Connection
Preferred DNS server DNS server IP address.
Alternate DNS server DNS server alternate address.
Transfer mode
LAN download
Advanced setup
The remote host can choose multi-cast and PPPOE to set. See Figure 5-26.
Function
It includes multiple-address, fault tolerance and load balance.
You need to select default network card if the network mode
is multiple-address.
You need to select Ethernet port here if the network mode is
multiple-address.
It is to auto search IP. When enable DHCP function, you can
not modify IP/Subnet mask /Gateway. These values are from
DHCP function. If you have not enabled DHCP function,
IP/Subnet mask/Gateway display as zero. You need to
disable DHCP function to view current IP information.
Besides, when PPPoE is operating, you can not modify.
Please input the corresponding number to input IP address.
Then you can set the corresponding subnet mask the default
gateway.
Here you can input the default gateway.
Default value is 37777. You can change if necessary.
Default value is 80.
Default value is 554.
Default value is 37778. You can change if necessary.
Network user max amount. The value ranges from 0 to 20.
O means there is no user can access current device.
Here you can select the priority between fluency/video
qualities.
System can process the downloaded data first if you enable
this function. The download speed is 1.5X or 2.0X of the
normal speed.
77