WatchNet ENX Series Manual page 82

Please refer to the following sheet for detailed information.
Parameter Function
Please select a channel first.
Channel
Pre-record Please input pre-record value here.
When alarm record or motion detection record occurs, system can
record the several seconds video before activating the record
operation into the file. (Depends on data size).
Setup In Figure 5-21, click set button, you can go to the corresponding
setup interface. See Figure 5-22.
Please set schedule period and then select corresponding record
type: schedule, motion detection, and alarm.
Please select date (Current setup applies to current day by default.
You can draw a circle before the week to apply the setup to the
whole week.)
After complete setup, please go back to Figure 5-21 and then click
save to save current time period setup.
Click Set button, system pops up a dialogue box shown as in Figure
Holiday
5-24.
Here you can set holiday date. Check the box, it means current channel
shall record as your holiday setup. Please go to the Period interface to
set the holiday date record setup.
Copy It is a shortcut menu button. You can copy current channel setup to
one or more (all) channels. The interface is shown as in Figure 5-23.
Please note the following figure is based on our 128-channel series
product and it is for reference only.
5.3.2.4 Network
Network interface is shown as in Figure 5-25.
System supports IPv4 and IPv6 addresses both.
IPv4
Please refer to the following sheet for detailed information.
Parameter
IP version
Figure 5-25 Network
Function
Here you can select IP address format. There are two
modes: IPv6/IPv4.
IPv6
76