WatchNet ENX Series Manual page 91

Parameter Function
Relay Out Enable alarm activation function. You need to select alarm output port
so that system can activate corresponding alarm device when alarm
occurs.
For 6-ch alarm output port device, the 6
+12V output.
System can delay the alarm output for specified time after alarm ended.
Alarm
The value ranges from 10 seconds to 300 seconds.
Latch
System auto activates current channel to record once alarm
Record
occurs (working with alarm activation function). Please note
Channel
current device shall be in auto record mode
System can delay the record for specified time after alarm ended. The
Record
value ranges from 10s to 300s.
Latch
Please draw a circle to enable email function. System can send out
Email
email to alert you when alarm occurs and ends.
After enabled, alarm info will be prompted out on the local output
Screen
end. That is to say, the alarm prompt will be displayed beside the
display
channel name on the local surveillance image.
Buzzer Once you check the box here, the buzzer beeps when an alarm
occurred.
Tour 
alarm occurs, system can begin one-window tour for the activated
record channel. Please set the tour time in the local end.
PTZ 
activation go to preset x when there is an alarm.
 The PTZ configuration events include preset, tour, and pattern.
Copy It is a shortcut menu button. You can copy current channel setup to
one or more (all) channels.
5.3.2.1 Detect
By analyzing video image, system will boot video detection alarm when it senses the motion
signal which meets the senility standard that is previously set. See Figure 5-35.
Display the selected video in local monitor window. When
Here you can set PTZ movement when alarm occurs. Such as
th
channel is the controllable
85