SHUT DOWN
6
6-70
RESET Menu Settings
IMPORTANT
Data from PCL/UFR II Printer Driver cannot be output.
•
If you have output data, the data being printed is deleted. Print the data from the
•
computer again.
When you are using an optional hard disk, set MODE TIMEOUT in the SETUP
•
menu to a setting other than OFF. It is recommended that you should specify the
default setting, 15 seconds if possible.
NOTE
The Job indicator is on when any print data remains in the printer memory or when
•
no print data remains in the printer but a job has not yet been completed.
If MODE TIMEOUT for a job is specified, data less than one page is also output
•
automatically when the specified time has elapsed (Data from PCL/UFR II Printer
Driver is not output.). MODE TIMEOUT for a job is set to 15 seconds in the default
settings.
If the Job indicator does not go off even after outputting the data, perform a soft
•
reset. (See the previous item)
-
Shuts down the functions of the hard disk.
If a hard disk is installed, the printer may be turned OFF during access to the hard
disk when you turn the printer OFF. To prevent this accident, shut down the
functions of the hard disk before turning the printer OFF.
If you select SHUT DOWN in the RESET menu, the message that asks you if you
execute a shut down appears. Pressing [OK] at this point executes the shut down.
After executing a shut down, the printer cannot receive data, and panel operation
is disabled. Cycle the power of the printer if you want to print the data again.
NOTE
This item is displayed only when an optional hard disk is installed, and HARD DISK
is set to ON.