SHUT DOWN
6
6-52
RESET Menu Settings
NOTE
The
(Job) indicator is on when any print data remains in the printer memory or
•
when no print data remains in the printer but a job has not yet been completed.
If MODE TIMEOUT for a job is specified, data less than one page is also output
•
automatically when the specified time has elapsed (Data from PCL/UFR II Printer
Driver is not output.). MODE TIMEOUT for a job is set to 15 seconds in the default
settings.
If the
(Job) indicator does not go off even after outputting the data, perform a
•
soft reset. (See the previous item)
-
It is recommended that you shut down the printer using the following procedure
when you want to turn the printer OFF.
1.
Press the
(Reset) key.
2.
Display SHUT DOWN in the RESET menu, then press [OK].
3.
<OK?> is displayed. Press [OK].
4.
When the message <TURN OFF POWER> appears, press "O" of the power switch.
After executing a shutdown, the printer cannot receive data, and panel operation
is disabled. Cycle the power of the printer if you want to print the data again.
NOTE
If you are using WSD, the shutdown notifies the computer that the printer is turned
OFF.