Interface Menu Options; I/F Connection; Mode Timeout - Canon Color image RUNNER LBP5360 User Manual

INTERFACE MENU Options

I/F CONNECTION

PARALLEL ............................ON*, OFF
USB ......................................ON*, OFF
NETWORK ...........................ON*, OFF
EXT.INTERFACE*
1
* EXT.INTERFACE is displayed only when the optional expansion interface board is installed.
Specifies the settings for the interfaces used for communication with the
computer, etc.
You can specify ON or OFF for each interface.
Even if multiple interfaces are set to ON, the printer automatically switches to the
one that received the data first. Therefore, you do not need to change the setting
in the printer each time you connect the printer to different types of interfaces at
the same time.
IMPORTANT
After changing the settings for this item, cycle the power of the printer or perform a
hard reset to make the settings effective.

MODE TIMEOUT

OFF, 5 to 300 seconds; 15 seconds*
Specifies the function to finish a job automatically.
If you specify the time the printer times out in this item, the printer can finish a job
automatically when the specified time has elapsed since no data is entered.
If this item is specified, the printer can output paper automatically when data is
remaining in the printer because of an application not sending the command to
output paper.
When OFF is specified, the printer does not use the function to finish a job
automatically.
IMPORTANT
If the function to finish a job automatically is specified, the job may be finished in
•
the middle of the process when the computer takes a long time to process the data.
In this case, adjust the time the printer times out.
When you are using an optional hard disk, specify the setting other than OFF for
•
this item. It is recommended that you should leave this item at the default setting,
15 seconds, if possible.
1
...............ON*, OFF
SETUP Menu Settings
6
6-45