Table of Contents
Advertisement
Remedy 2 Perform a soft reset using the RESET menu, increase the free space of RAM
using the following procedure, register the data again, and then print again.
• Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory will be deleted).
• Install an optional expansion RAM module. (See "Installing RAM," on p. 9-15)
<26 SYS.MEM.FULL>
Cause
The work memory required for the printer process has run out while the system
is processing the data (mainly the graphics data and text data).
Remedy 1 The printer continues printing by pressing [Online]. However, the data with
which an error has occurred is not printed properly.
Remedy 2 Perform a soft reset using the RESET menu, and then increase the free space
of RAM using the following procedure.
• Perform a hard reset or cycle the power of the printer (Be aware that all the
data in the memory will be deleted).
• Install an optional expansion RAM module. (See "Installing RAM," on p. 9-15)
<27 JOB START ERR>
Cause
The specified emulation does not exist.
Remedy
Press [Online] to continue printing from the next data. However, the data with
which an error has occurred is not printed.
<30 MEMORY FULL>
Cause 1
The work memory has run out while the system is processing the data.
Remedy
The printer continues printing by pressing [Online]. However, the data with
which an error has occurred may not be printed properly.
Cause 2
(If this error has occurred while the printer is ON) The amount of memory
specified in NVRAM could not be secured because the memory construction
had been changed (The expansion RAM is removed).
Remedy 1 The printer continues printing by pressing [Online]. However, the data may not
be printed properly due to the change of the memory construction.
IMPORTANT
The memory construction of NVRAM is rewrote to a securable value when <30
MEMORY FULL> appears. (* The settings for RIP Once and the hard disk is restored to
the default value.) (See "SETUP Menu Settings," on p. 6-13)
<Auto Error Skip>
<Auto Error Skip>
<Auto Error Skip>
Message List
8-37
8
Advertisement
Table of Contents
