Table of Contents
Advertisement
The printing position is skewed.
Cause 1
GUTTER, OFFSET Y, or OFFSET X in the LAYOUT MENU options in the
SETUP menu is specified.
Remedy
Set GUTTER, OFFSET Y, or OFFSET X in the LAYOUT MENU options in the
SETUP menu to "0", and then print again.
Cause 2
"Top Margin" and "Paper Position" in the application are not specified properly.
Remedy
Specify the settings for "Top Margin" and "Paper Position" in the application
properly, and then print again. (See the instruction manual supplied with your
application)
Cause 3
The printing position has been adjusted using ADJ.START POS. in the USER
MAIN. options in the SETUP menu.
Remedy
Adjust the printing position to the appropriate value using ADJ.START POS. in
the USER MAIN. options in the SETUP menu. (See "Adjusting the Printing
Position," on p. 7-21)
The next page is printed from halfway across the previous page.
Cause
"Line Spacing" or "Lines/Page" in the application is not specified properly.
Remedy
Specify the settings for "Line Spacing" and "Lines/Page" in the application so
that data fits in one page, and print again. (See the instruction manual supplied
with your application)
Data is printed with its size reduced.
Cause
The printer is set to reduce the print size.
Remedy
Confirm the setting for [Manual Scaling] in the printer driver. (See Driver Guide)
Paper comes out wrinkled.
Cause 1
Paper is loaded in the paper cassette or multi-purpose tray at an angle.
Remedy
Load the paper in the paper cassette or multi-purpose tray straight. (See
"Loading Paper in the Paper Cassette," on p. 4-19, "Loading Paper in the
Multi-purpose Tray," on p. 4-36)
Cause 2
Paper is damp since the paper has been stored in unsuitable condition.
Remedy
Replace the paper with new one and print again. (See "Paper Requirements,"
on p. 4-2)
When You Cannot Obtain Appropriate Printout Results
8
8-55
Advertisement
Table of Contents
