Table of Contents
Advertisement
When the Duplex Unit Is Not Installed Properly
If the duplex unit supplied with this printer is not installed properly, the message
<0F OPT.CONN.ERR.> appears in the display.
Install the duplex unit properly using the following procedure.
IMPORTANT
To install the duplex unit properly, remove it once. When you remove the duplex unit, the
data being printed will be deleted because you have to turn the power of the printer OFF.
Print the data again after installing the duplex unit properly.
1
Turn the power of the printer OFF.
If you are using a hard disk, turn the printer OFF after performing a shutdown
using the RESET menu.
If you are not using a hard disk, make sure that the Job indicator is off and that
the printer is not printing by checking the display.
When the Duplex Unit Is Not Installed Properly
8
8-27
Advertisement
Table of Contents
