UPDATE FIRMWARE
■ USB
■ NETWORK
1ST CALIBRATION
6
PCL SETUP Options
PAPER SAVE
6-56
SETUP Menu Settings
-
This item is to be executed only when the firmware of the printer needs to be
updated.
-
This item is to be executed only when the firmware of the printer needs to be
updated.
AFTER JOBS*, IMMEDIATELY
When you turn the printer ON, calibration is performed depending on the inside
state of the printer. Specify the timing of calibration.
If AFTER JOBS is specified, calibration is performed at the completion of the first
printing after the printer is turned ON.
If IMMEDIATELY is specified, calibration is performed immediately after the printer
is turned ON. When calibration is performed immediately after the printer is turned
ON, excessive time is required until the printer is ready to print.
OFF*, ON
Specifies whether the printer outputs the blank page that can be created due to
no data existing between two Form Feed codes sent from an application.
If ON is specified, the printer does not output the blank page. If OFF is specified,
the printer outputs the blank page.
If you use this function, you can save paper because the blank pages are not
output.