Table of Contents
Advertisement
NOTE
• This printer recognizes the type of Ethernet (100BASE-TX or 10BASE-T) automatically.
• If both 100BASE-TX devices and 10BASE-T devices are on the same network, a device
such as a switching hub that supports both 100BASE-TX and 10BASE-T is required. For
more details, contact your local authorized Canon dealer.
• If you connected this printer to a network, check the MAC address of the print server with
Configuration Page Print, and then configure the network operating system (UNIX, etc.)
and print server. For more details, see "Network Guide".
1
Connect the LAN cable to the LAN connector of the printer.
Connect a LAN cable that is compatible with the LAN connector of the network
board according to the network.
2
Connect the other end of the LAN cable to the hub.
● Installing the Software
After connecting the LAN cable, install the software for this printer. For more
details, see "Driver Guide".
Connecting the Cables
2
2-29
Advertisement
Table of Contents
