Netware Network Setup Procedures - Canon imageRunner C5051 Getting Started

NetWare Network Setup Procedures

To use a NetWare network, it is necessary to perform the following procedures.
1
NetWare Print Service Settings (See e-Manual > Network)
Specify the NetWare print service settings. (Optional equipment is required to print or send a fax from a computer. For the equipment needed, see "Optional Equipment and
System Requirements for Connecting to a Network, " on p. 4-2.)
To specify the settings from the computer, use:
•
NWADMIN or PCONSOLE (Novell software provided with NetWare)
•
Canon utilities
2
Protocol Settings (See "Protocol Settings," on p . 7-3 .)
Specify the protocol settings. To specify the settings, use:
•
The machine's control panel
•
The Remote UI (via a web browser)
•
Canon utilities
3
Computer Settings for Printing/Sending a Fax (See e-Manual > Network)
7
Specify the settings of each computer you use for printing or sending a fax. (Optional equipment is required to print or send a fax from a computer. For the equipment
needed, see "Optional Equipment and System Requirements for Connecting to a Network, " on p. 4-2.)
•
It is recommended that steps 1 and 2 above be performed by the network administrator.
•
To configure settings with software other than the control panel of the machine, NWADMIN, or PCONSOLE, TCP/IPv4 protocol must be
supported by your network environment (IPv6 is not supported).
•
If you are using the imagePASS or the PS-GX, see the manual provided with the imagePASS or the PS-GX.
•
If you are using the imagePASS or the PS-GX, some functions are not available with this machine. For details, see the manual provided with
the imagePASS or the PS-GX.
7-2
NetWare Network Setup Procedures