Fax Tx Report/Fax Error Tx Report - Canon imageRunner C5051 Getting Started

SEND DOCUMENT NAME
The name given to the document when the send settings were specified is printed.
TX/RX INCOMPLETE
If the transmission has been interrupted, the name and address of the destination are printed.
TRANSACTION OK
If the transmission completed successfully, the name and address of the destination are printed.
ERROR
If a sending error occurs, the name and address of the destination are printed.
If a field exceeds its display capacity, only those characters that fit in the display are printed.

Fax TX Report/Fax Error TX Report

This report indicates items, such as the fax number of the party to which you sent documents, the result of communication,
and other information, to enable you to check whether the documents were sent correctly to the intended destination.
You can set whether to automatically print a Fax TX Report after sending documents. (See e-Manual > Settings/Registration.)
•
This mode is available only if the FAX Board is installed.
•
You can also print a Fax TX Report with an image of the sent original attached to it. (See e-Manual > Settings/Registration.)
REPORT NAME
When the document transmission is completed successfully, a Fax TX Report is printed. When a send error occurs, a Fax Error TX Report is
printed.
MESSAGE
A message describing the transmission result is printed.
JOB NO .
The four digit number, that is automatically assigned when the document is accepted for sending, is printed.
DEPT . ID
16
If Department ID Management is set, the Department ID is printed.
DESTINATION ADDRESS
The fax number of the destination is printed, up to the first 48 digits.
PSWD/SUBADDRESS
A subaddress is printed, if specified. The password is not printed to maintain security.
16-6
Reports