Before You Start The Remote Ui - Canon imageRunner C5051 Getting Started

Before You Start the Remote UI

Before you start the Remote UI, perform the following:
Specify the Network Settings
Specify the settings under Network in Preferences (from the Settings/Registration screen) and find out the machine's IP address. If you do
not know the machine's IP address, consult your network administrator. (See "Protocol Settings, " on p. 6-3.)
Enable the Remote UI
Set Remote UI in Management Settings (from the Settings/Registration screen) to 'On' . It is also recommended that Device Information
Settings in Device Management (from the Settings/Registration screen) is configured.
•
Connection via a proxy server is not possible. If your system environment has a proxy server, perform the following setting. (Settings vary
according to the system environment, consult your network administrator.)
- Enter the IP address of the machine into Exceptions in the web browser proxy server settings.
•
You must set your web browser to enable all cookies and use JavaScript. Otherwise, you will not be able to change the machine's settings
using the Remote UI.
•
If the control panel of the machine is being used for a particular operation and if you use the same operation on the Remote UI, the last
setting is activated.
•
If multiple Remote UIs are running simultaneously, the latest setting that was made is enabled. It is recommended that only one Remote
UI be running at a time.
•
To enter characters from a web browser, use the characters that you can enter from the touch panel display of the machine. If you use the
other characters, they may not be displayed/recognized properly on the machine.

Before You Start the Remote UI

15
15-3