Logging In To The Machine As An Administrator - Canon imageRunner C5051 Getting Started

Logging In to the Machine as an Administrator

To specify the settings, you must log in to the machine as an administrator.
The operations available on the Settings/Registration screen vary between administrator and general user.
- For Administrator:
The Administrator can specify all of the system settings of the machine. As a default, system manager settings (System Manager
ID/System Password) are set on the machine. Thus, the Administrator must log in by entering the System Manager ID and the System
Password on the Settings/Registration screen. The default setting for both the System Manager ID and System Password is '7654321' .
We recommend that you change both the System Manager ID and System Password. (See e-Manual > Settings/Registration.) For
2
information on the settings that can only be set by the Administrator, see e-Manual > Security.
- For General Users:
Some operations on the Settings/Registration screen may be restricted. Operations that are restricted are grayed out and cannot be
selected.
This section describes the procedures assuming that the machine is in default setting. If the Department ID Management or
authentication for SSO-H is set, enter the necessary items for each log in.
1
Press
2
Press [Log In] .
2-6
Operations Required to Use the Machine
.