830
Users Manual
and highlight 'Yes' then confirm selection by pressing
Use
/
.
ENTER
The new RPM value overrides the value initially entered during set-up. Coupling
tolerances will now be based on this accepted RPM value.
Laser beam adjustment
After entering all required dimensions, the measurement screen appears auto-
matically.
Switch the wireless module on using the little silver toggle switch found in the
back on the right side. The battery status LEDs blink for three seconds. The
module is now ready for operation. It activates the laser, if the wireless module is
connected to the sensor.
If using the RS232 interface, the laser is activated when the straight-ended plug
of the sensor cable is inserted into the Product's blue sensor port.
The sensor and prism need to be adjusted so that the laser beam strikes the
prism and is reflected back into the sensor.
60