Appendix; Using The Sensor Cable; Figure 10-1. Replacing The Wireless Module Cable With The Sensor Cable - Fluke 830 User Manual

Appendix

Using the sensor cable

10. Appendix
Using the sensor cable
If you need to use the sensor cable (due to flat batteries in the wireless module)
then it must be properly attached to the sensor. To attach the sensor cable
proceed as follows:
Open the front of the sensor housing
Unscrew the left-hand locking knob as shown in Figure 10-1, then lift off the front
of the sensor housing. Note how the wireless module cable is held in place by
grooves in the sensor frame.
Screw-type locking
Front housing
Clamping screw
Locking knob

Figure 10-1. Replacing the wireless module cable with the sensor cable

Unscrew and remove wireless module cable
Undo the screw-type locking, and carefully lift the wireless module cable out of its
guide grooves.
Attach sensor cable
Insert the angled plug into the sensor socket as shown in Figure 10-2; note the
keyway indicating proper plug orientation. Tighten the screw-type locking to
fasten the cable connection.
121