Figure 6-3. Centering The Reflected Laser Beam Using - Fluke 830 User Manual

830
Users Manual
Figure 6-3. Centering the reflected laser beam using the thumbwheel and
the yellow beam adjustment knob
When making the above adjustments, observe the product's alignment condi-
tion LED and the dot on the display screen. When the LED turns yellow, this
is an indication that the reflected beam position is OK and measurement can
proceed. When the LED turns green, the dot is centered in the target square.
After centering the laser dot, rotate shaft to the first measurement position.
Measurement can only be taken when the sector in which the shaft has been
positioned is highlighted green. Press
The sector is then highlighted orange, an indication that measurement has been
taken in that particular sector.
44
Note
to take the measurement point.
ENTER