180LR, 180LG
Users Manual
Check Product Accuracy
Periodically check the accuracy of the Product.
Check Accuracy of Horizontal Laser
To check the accuracy of the horizontal laser:
1. Find a horizontal site that is almost level, preferably a
concrete slab, that is ≥7.62 m (25 ft) wide with two
opposing walls to use as targets. You can also use
scrap wood as targets. See Figure 5.
2. Put the Product about 15 cm (6 in) from target
3. Point the horizontal laser at target
4. Put a mark
at the point where the horizontal laser
intersects the target area.
5. Turn the Product 180 ° on its center so that the
horizontal laser intersects with target
6
6. Put a mark
7. Repeat steps 2 through 6 with the Product 15 cm from
8. Measure the distance between mark
9. If the distances are not the same, subtract the lesser
.
.
.
at the point where the horizontal laser
intersects the target area.
target
.
on target
and mark
If the distances are the same, the laser is within
calibration.
measurement from the greater measurement and divide
by two to calculate the difference of error.
If the distance is ≤3 mm @ 9 m, the laser is within
calibration accuracy.
and mark
and mark
on target
.