Table of Contents
Advertisement
Horizontal shaft alignment
Live Move
When the marking on the color-coded tolerance bar is on either the green or
yellow section, the alignment condition is within tolerance. Proceed to tighten the
anchor bolts.
Tighten the anchor bolts
Tighten anchor bolts, then press
or
to recheck the alignment
ENTER
BACK
condition after Move.
If machine moves while tightening correct soft foot first and also check for a
cocked anchor bolt and dished washer, then realign.
Re-measure after Move - machine in tolerance?
Since the machine has been moved, earlier results are no longer valid. With
to confirm
'Stop and Measure' highlighted after Move is completed, press
ENTER
selection. On confirmation, the measurement mode is initialized. If necessary,
center laser beam and take another set of measurements. If the diagnosis is
within required tolerance, then the machines are aligned.
77
Hide quick links:
Advertisement
Table of Contents
