Figure 4-7. Wireless Module On/Off Switch - Fluke 830 User Manual

Switch the wireless module on

Figure 4-7. Wireless module ON/OFF switch

After connecting the sensor to the wireless module, switch the wireless module
on (see Figure 4-7).
The battery status LEDs blink for 3 seconds. The module is now ready for
operation. When the module is switched on, it supplies power to the sensor. If no
measurement action is activated in the Product, the power supply to the sensor
stops.
Operating time of battery status LED indicators
State of LEDs
3 LEDs lit continuously
2 LEDs lit continuously
1 LED lit continuously
Only 1 LED blinking (slowly)
Only 1 LED blinking (very fast)
The operating time may vary significantly depending on the type of batteries
used.
Wireless module ON/OFF switch
Indicates
Operating time is between
75%–100%
Operating time is between
50%–75%
Operating time is between
25%–50%
Operating time is under 25%
Operating time in critical phase.
Measurement should not be taken
Note
Overview
Wireless module
23