Fluke 830 User Manual page 131

Using the navigation keys, highlight the 'Sensor selection' icon, then press
to confirm selection.
In the selection window that appears, use
1 (RS232)'. Confirm selection by pressing
With the sensor dust cap fitted, press
indicator LED of the sensor should blink to indicate beam emission. If not, ensure
that the sensor cable has been properly connected; otherwise, contact FLUKE.
Both sensor and wireless module cables may be replaced in the same manner
as described in this chapter.
/ and highlight the item 'Port
. The serial port is now initialized.
ENTER
to activate the laser. The red
MEASURE
Note
Appendix
Testing cable connection
ENTER
123