Fluke 830 User Manual page 127

2. Confirm selection by pressing
3. On confirmation the screen used to position the sensor and prism for optimal
moves appears.
4. Rotate shaft to any of the four positions highlighted in green. These are 1:30,
4:30, 7:30 and 10:30.
5. Use the navigation keys to position the sensor on the screen to correspond to
the position of the sensor and prism on the shafts.
6. Press to start Live Move. The Move direction dialog window appears.
ENTER
7. Use either or to highlight the required direction of movement. This could
be either or
9 3
0 6
If the laser beam is centered, Live Move starts automatically. If beam is not
centered, a hint to center the laser beam appears on the display.
.
ENTER
. Confirm selection by pressing
Note
Vertical flanged machines
.
ENTER
Correcting offset
119