Figure 7-1. Mounting The Bracket Step-By-Step - Fluke 830 User Manual

2. Fasten the support posts in place by tightening the hex screws on the sides of
the bracket frame.
3. Place the bracket on the shaft or coupling. Wrap the chain around the shaft
and feed it through the other side of the bracket: If the shaft is smaller than
the width of the bracket frame, insert the chain from the inside of the bracket
as shown in Figure 7-1; if the shaft is larger than the bracket width, insert the
chain into the frame from the outside.
4. Catch the chain loosely on the anchor peg.
5. Turn the bracket thumbnut to tighten the assembly onto the shaft.
6. Clip the loose end of the chain back onto itself.
Anchor peg
1
2

Figure 7-1. Mounting the bracket step-by-step

The bracket should now be tight on the shaft. Do not push or pull on the bracket
to check, since this could loosen its mounting.
To remove the brackets, loosen the thumbnut, then remove the chain from its
anchor peg.
The compact chain-type brackets cover most situations, but in cramped or
special cases, the optional compact magnetic bracket may be useful.
3
Note
Horizontal shaft alignment
4
5
6
Mount brackets
49