Figure 4-2. Charging The Non-Removable Rechargeable Battery - Fluke 830 User Manual

830
Users Manual
USB port
(grey)

Figure 4-2. Charging the non-removable rechargeable battery

Before charging, the rechargeable battery should be discharged as much as
possible. To charge the battery from 0% to 100% capacity takes approximately
4 hours.
The battery LED indicates the charging status of the battery. The LED flashes
green at initialization and during the charging process. A constantly lit green LED
denotes that the battery is fully charged.
The charge level of the battery is displayed under the menu item 'Device
settings'. With system switched on, pressing
keys to highlight 'Config'. Confirm selection by pressing
configuration menu use the navigation keys to highlight 'Device setting'. Confirm
selection by pressing
ENTER
16
Note
, then using the navigation
MENU
. The device settings are displayed.
Charger/adapter is
connected to the Product
via the USB port.
and from the
ENTER
830 LASER ALIGNMENT TOOL
SETUP MEASURE DIAGNOSE MENU
› ABC DEF
1 2 3
GHI JKL MNO
4 5 6
PQRS TUV WXYZ
7 8 9
CLEAR ENTER
space
+ - 0 . / .
BACK