Magneto Rotor Removal - Linhai 2004 ATV 260 Service Manual

CHAPTER 3A ENGINE
Order Job name/ Part name
A.C. magneto and starter clutch
removal
1 Rotor
2 Shaft (idle gear)
3 Idler gear
4 Starter one way clutch assembly
5 Woodruff key
6 Starter wheel gear
A.C. MAGNETO ROTOR REMOVAL
1. Remove:
Nut (rotor)
Plain washer
NOTE:
Loosen the nut (rotor)
with a sheave holder
Do not allow sheave the holder touch to the
projection on the rotor.
2. Remove:
Rotor
Woodruff key
NOTE:
Remove the rotor
Center the flywheel puller over the rotor.
Make sure after installing the holding bolts that the
clearance between the flywheel puller and the
rotor is the same everywhere. If necessary, one
holding bolt may be turned out slightly to adjust
the flywheel puller's position.
CAUTION:
Cover the crankshaft end with the box wrench for
protection.
STARTER DRIVE GEAR INSPECTION
260/ 300 / 400 cc
while holding the rotor
.
using the flywheel puller.
Q'ty
Remove the parts in order.
1 Refer to "A.C. MAGNETO ROTOR
REMOVAL /INSTALLATION" section.
1
1
1
1 Refer to "ROTOR INSTALLATION"
1 section.
Reverse the removal procedure for
installation.
ATV SERVICE MANUAL09.0
Remarks
CHAPTER 3 ENGINE PAGE. 3A- 52