Fuel Level Sensor Inspection - Linhai 2004 ATV 260 Service Manual

CHAPTER 8 ELECTRICAL
ATV SERVICE MANUAL 09.0
Segment"RES"should blink.
With the fuel level sensor float at the top (FULL)
position, turn the ignition switch to "ON" and
check the fuel gauge. All segments up to
segment "F"should come on.
If the fuel gauge does not function properly,
check the fuel level sensor
If the fuel level sensor is OK, replace the LCD
Meter.
RESISTANCE(20℃/

Fuel level Sensor Inspection

FLOAT POSITION
68°)
Disconnect the fuel level sensor 2p Green
connector and connect the ohmmeter to the
TOP(FULL) 4-10Ω
sensor side connector terminals.
BOTTOM(RESERVE) 100-110Ω
Measure the fuel level sensor resistance with the
float at the top (FULL)
And bottom (RESERVE) positions.
CHAPTER 8 ELECTRICAL CTRICAL PAGE 8- 39